Aloha Roof Pros provides professional roof coatings & sealing in Aloha, OR for residential and commercial properties across the Tualatin Valley. We install coatings and we decline more coating work than we accept. Almost every refusal answers the same request: somebody wants a composition roof painted over in order to squeeze a few more years out of it.
It does not work. A coating film laid over granulated asphalt cannot bond the way it needs to, it traps moisture inside a mat built to breathe, and it puts the manufacturer's warranty permanently out of reach from the day it goes on. Two or three winters later the original trouble is still there beneath a surface nobody will warrant. Manufacturers say the same thing in their own literature, which is worth reading first.
Coatings belong on metal and on sound low-slope membrane. An aged standing seam or corrugated panel roof over a shop, a barn or an outbuilding makes an excellent candidate. Seams are stripped in with reinforcing fabric, fasteners get treated one by one, and the field takes an elastomeric topcoat that genuinely extends service life. Surface preparation carries the job, so panels get washed, rust gets treated and loose fasteners get replaced before any coating.
The same holds for a modified bitumen or single-ply roof that has weathered but remains structurally intact. Restoring one of those defers a large capital expense legitimately, and for a commercial owner whose replacement year has not arrived yet, it is frequently the correct financial decision rather than a compromise. We measure moisture in the insulation first, though, because a wet core sealed under a fresh coating simply keeps rotting quietly out of sight.
The test we apply is short. If the substrate is sound and the failure is surface weathering, coating it makes sense. If the substrate is failing, saturated, or moving underfoot, no coating on the market will correct that, and you will read as much on the estimate we hand you. Mil thickness gets measured wet during application rather than estimated afterward, since a coating applied thin fails early and looks identical on the day it goes on.
We also refuse coating work on any plane where we cannot establish what lies beneath it. Sealing across an unknown assembly conceals a condition instead of curing it, and it becomes somebody's expensive surprise a few years out, usually the next owner's. That is not a job we want our name attached to. The cheapest version of this decision is the one made with the roof open, and the most expensive is made later.
Our licensed and insured team brings the right materials and equipment to every job — metal connector plates read tooth by tooth from the attic floor, the clear opening of a little over twenty-two inches between chords, a stamped repair detail drawn by an engineer for an altered chord, tubular daylight devices threaded between web members, self-adhered membrane at valleys and every roof penetration, gable end frames that carry no triangulated webbing — and backs the work with a written workmanship warranty. We serve Aloha and nearby communities including Beaverton, Hillsboro, Cedar Hills, West Slope.
What We Handle
Everything our roof coatings & sealing in Aloha covers
One crew, one point of contact, and the full range of roof coatings & sealing work in Aloha, OR. If it is on this list we do it in house rather than handing it to a subcontractor:
- roof coating Aloha OR
- elastomeric roof coating
- metal roof coating
- low slope roof restoration coating
- acrylic roof coating Oregon
- roof sealant application
- coating versus replacement
- silicone roof coating
- flat roof recoating
- metal roof seam sealing
- commercial roof restoration coating
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Aloha services.
Materials, equipment and how we do roof coatings & sealing
The difference between roof coatings & sealing that lasts and roof coatings & sealing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with metal connector plates read tooth by tooth from the attic floor, the clear opening of a little over twenty-two inches between chords, a stamped repair detail drawn by an engineer for an altered chord, tubular daylight devices threaded between web members, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Aloha job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Tualatin Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do roof coatings & sealing outside Aloha
Aloha Roof Pros covers Aloha and the surrounding communities of the Tualatin Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Roof Coatings & Sealing in Beaverton, OR — Washington County, population 97494
- Roof Coatings & Sealing in Hillsboro, OR — Washington County, population 106447
- Roof Coatings & Sealing in Cedar Hills, OR — Washington County, population 8379
- Roof Coatings & Sealing in West Slope, OR — Washington County, population 7223
- Roof Coatings & Sealing in Rockcreek, OR — Washington County, population 9862
- Roof Coatings & Sealing in Cornelius, OR — Washington County, population 12694
Start on the Aloha Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Aloha Chooses Aloha Roof Pros
- ✓We read the truss framing from inside the attic before we price a single square, because on Aloha's housing the manufactured geometry overhead decides what is actually possible on the plane above it.
- ✓Our estimates are written per plane, so the trussed main roof and the addition or carport each get their own assembly rather than being averaged into one number that fits neither.
- ✓We refuse coating work over composition roofs and we say so in writing, because a film over granulated asphalt seals in moisture and puts the manufacturer's warranty out of reach permanently.
- ✓We will talk you out of a hail claim this climate does not support, since western Oregon sees severe hail rarely and a withdrawn claim sits on your loss history for years.
The standards behind roof coatings & sealing
Quality here is not a matter of opinion — it is written down. The roof coatings & sealing work we do in Aloha follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every roof coatings & sealing project in Aloha gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free roof coatings & sealing free estimate in Aloha, or request a quote and we'll get right back to you.